Avaya Configuring DLSw Services Manual do Utilizador Página 36
- Página / 256
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Configuring DLSw Services
1-10 114063 Rev. A
SDLC Support
The Bay Networks integrated SDLC support merges the low-speed SDLC traffic
of an SNA network with the high-speed, multiprotocol traffic of LANs into a
single network backbone. SDLC operates in DLSw single switch routers, or in
dual switch-to-switch networks, as illustrated in
Figure 1-1.
DLSw integrated SDLC supports devices configured as primary or secondary link
stations to the router.
A link station is a logical connection between adjacent nodes, where one node is a
primary link station and the other node is a secondary link station. SDLC supports
primary and secondary link stations. A primary link station does the following:
• Controls a data link
• Issues commands
• Initiates error recovery procedures
A secondary link station receives commands and responds to polls initiated by the
primary SDLC link station.
You can use integrated SDLC in a point-to-point or multipoint topology.
Point-to-point connects one SDLC device to another. Multipoint connects several
secondary SDLC devices to one primary SDLC device. You specify the topology
when you configure SDLC on the synchronous circuit.
For more information on the Bay Networks SDLC implementation, see
Configuring SDLC Services.
Integrated SDLC Conversion
Integrated SDLC conversion enables existing SDLC traffic to share a backbone
network with LAN traffic without an intervening TCP/IP network. Traffic enters
the DLSw router as SDLC and goes out the router as LLC2 over Token Ring or
Ethernet. The destination endstation can reside on the Token Ring or Ethernet
directly connected to that DLSw router. SRB can forward the traffic through the
network to a destination host or endstation. In this network, the local router
performs the SDLC conversion, and forwards the traffic across the network to the
host
(Figure 1-5).
- Configuring DLSw 1
- Services 1
- Bay Networks Software License 3
- Contents 5
- 114063 Rev. A vii 7
- 114063 Rev. A ix 9
- 114063 Rev. A 10
- 114063 Rev. A xi 11
- 114063 Rev. A xiii 13
- 114063 Rev. A xv 15
- About This Guide 17
- Before You Begin 18
- Conventions 18
- Acronyms 19
- 114063 Rev. A xxi 21
- Bay Networks Customer Service 22
- World Wide Web 23
- Customer Service FTP 23
- Support Source CD 24
- CompuServe 24
- InfoFACTS 25
- How to Get Help 25
- Chapter 1 27
- Data Link Switching Overview 27
- DLSw Networking Overview 28
- RFC1795 Support 29
- 1-4 114063 Rev. A 30
- Single-Switch Services 32
- DSW0002A 33
- Dual-Switch Services 34
- SDLC Support 36
- 1-12 114063 Rev. A 38
- Primary SDLC Support 39
- Secondary SDLC Support 40
- 1-16 114063 Rev. A 42
- (b) Dual-Switch DLSw Networks 43
- Frame Relay Support 44
- DLSw Filtering 46
- Protocol Prioritization 47
- Chapter 2 49
- DLSw Implementation Notes 49
- DLSw Session Setup 50
- Combining DLSw and SRB 51
- 2-4 114063 Rev. A 52
- DSW0009A 52
- Virtual Rings 53
- DLSw and SRB On a Circuit 54
- DLSw and Bridging Services 55
- DLSw with Translation Bridge 56
- 2-10 114063 Rev. A 58
- Multiple DLSw Peers on a LAN 59
- Memory Requirements 60
- TCP Considerations 60
- Flow Control 61
- LLC2 Flow Control 62
- TCP Flow Control 62
- DLSw Prioritization 63
- Chapter 3 65
- DLSw Configuration Overview 65
- 114063 Rev. A 3-3 67
- 3-4 114063 Rev. A 68
- DLSW Global Parameters 69
- DLSw SAP Table 70
- SAP Table 71
- 3-8 114063 Rev. A 72
- DLSw Global Parameters 73
- DLSw Slot Table 74
- DLSw Configuration Overview 75
- 3-12 114063 Rev. A 76
- DLSw Peer IP Table 77
- Broadcast Peers 78
- Unconfigured Peers 79
- SDLC Line Parameters 80
- Local Devices 81
- 3-18 114063 Rev. A 82
- Boundary Access Node (BAN) 83
- 3-20 114063 Rev. A 84
- Configuring DLSw Packaging 85
- 3-22 114063 Rev. A 86
- Chapter 4 87
- Starting DLSw the First Time 88
- 4-4 114063 Rev. A 90
- 2. Click on OK 90
- Adding Slot IP Addresses 92
- 114063 Rev. A 4-7 93
- Adding DLSw Peer IP Addresses 94
- 114063 Rev. A 4-9 95
- 4-10 114063 Rev. A 96
- 1. Click on Add 96
- 114063 Rev. A 4-11 97
- 4-12 114063 Rev. A 98
- 99
- 100
- 101
- 101
- 102
- Starting DLSw 103
- 5. Click on Add 103
- Configuring DLSw Services 104
- 4-18 114063 Rev. A 104
- 105
- 4-20 114063 Rev. A 106
- 4-22 114063 Rev. A 108
- 109
- 4-24 114063 Rev. A 110
- 111
- 4-26 114063 Rev. A 112
- 4-28 114063 Rev. A 114
- Mapping Frame Relay Addresses 115
- 4-30 114063 Rev. A 116
- 3. Click on OK 116
- Chapter 5 119
- Editing DLSw Parameters 119
- Accessing DLSw Parameters 120
- (Figure 5-1) and then: 121
- (Figure 5-2) 121
- Click on OK 122
- 5-6 114063 Rev. A 124
- 5-8 114063 Rev. A 126
- 128
- 5-12 114063 Rev. A 130
- Enabling a DLSw Interface 131
- 5-16 114063 Rev. A 134
- (Figure 5-7) 135
- 114063 Rev. A 5-21 139
- 5-22 114063 Rev. A 140
- 3. Click on Done 140
- 5-28 114063 Rev. A 146
- 2. Click on Delete 146
- Adding a DLSw SAP Table Entry 147
- 114063 Rev. A 5-31 149
- Click on Done 150
- 3. Click on Delete 151
- 5-34 114063 Rev. A 152
- 4. Click on Done 152
- (Figure 5-19) 153
- 5-40 114063 Rev. A 158
- 2. Select the entry to edit 161
- Click on Apply 162
- 5-46 114063 Rev. A 164
- 114063 Rev. A 5-47 165
- 5-48 114063 Rev. A 166
- (continued) 169
- 5-52 114063 Rev. A 170
- (continued) 170
- 5-54 114063 Rev. A 172
- 5-56 114063 Rev. A 174
- 5-58 114063 Rev. A 176
- Deleting DLSw from the Node 177
- Chapter 6 179
- Using DLSw Prioritization 179
- 6-2 114063 Rev. A 180
- DLSw Priority Queues 181
- The Enqueuing Process 182
- The Dequeuing Process 182
- 114063 Rev. A 6-5 183
- 6-6 114063 Rev. A 184
- Queue Depth 185
- 6-8 114063 Rev. A 186
- 114063 Rev. A 6-11 189
- 6-12 114063 Rev. A 190
- 191
- 6-16 114063 Rev. A 194
- 114063 Rev. A 6-19 197
- 114063 Rev. A 6-21 199
- 6-24 114063 Rev. A 202
- 2. Click on Template 202
- 114063 Rev. A 6-29 207
- Configuration window 208
- (Figure 6-23) 208
- Appendix A 211
- DLSw Default Settings 211
- A-2 114063 Rev. A 212
- A-4 114063 Rev. A 214
- Appendix B 215
- Predefined DLSw Criteria 216
- DLSw Reference Points 216
- Length (bits) 217
- Specifying MAC Address Ranges 218
- B-6 114063 Rev. A 220
- Table B-6. SAP Codes 220
- Appendix C 221
- DLSw Troubleshooting 221
- *. Enabled by default 222
- Table C-2. DLSw State Table 223
- Sample Log Entries 224
- C-6 114063 Rev. A 226
- Reviewing the Network Log 228
- C-10 114063 Rev. A 230
- C-12 114063 Rev. A 232
- Troubleshooting DLSw 233
- C-16 114063 Rev. A 236
- Unexpected protocol action 238
- TCP open error 29 238
- DLSw Troubleshooting Tables 239
- C-20 114063 Rev. A 240
- C-22 114063 Rev. A 242
- C-24 114063 Rev. A 244
- C-26 114063 Rev. A 246
- Verifying the WAN Cabling 247
- 114063 Rev. A Index-1 249
- 114063 Rev. A Index-3 251
- 114063 Rev. A Index-5 253
- 114063 Rev. A Index-7 255
Manuais e produtos relacionados com Redes Avaya Configuring DLSw Services
Redes Avaya Configuring Branch Office Tunnel between a Contivity and a BayRS Router Manual do Utilizador
(29 páginas)
(29 páginas)
Redes Avaya Call Center Reporting Guia do Utilizador
(37 páginas)
(37 páginas)
Redes Avaya Quick2Config Manual do Utilizador
(110 páginas)
(110 páginas)
Redes Avaya BSG8/12 1.0 Guia de Configuração
(200 páginas)
(200 páginas)
Redes Avaya 1150E Guia do Utilizador
(200 páginas)
(200 páginas)
Redes Avaya BayRS Version 15.0.0.0 Aviso
(72 páginas)
(72 páginas)
Redes Avaya BCM450 Guia de Configuração
(12 páginas)
(12 páginas)
Redes Avaya BayRS Version 12.10 Manual do Utilizador
(194 páginas)
(194 páginas)
Redes Avaya BCM 2.0 Networking Manual do Utilizador
(42 páginas)
(42 páginas)
(32 páginas)
Redes Avaya Configuring SMDS Manual do Utilizador
(50 páginas)
(50 páginas)
Redes Avaya BayRS Version 15.4.2.0 Aviso
(72 páginas)
(72 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.051 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais