
Configuring Traffic Filters and Protocol Prioritization
7-2
• Temporarily disable or enable a filter, described in “Enabling or Disabling an
Outbound Filter.”
• Remove a filter from an interface, described in “Deleting an Outbound Filter.”
Displaying the Priority/Outbound Filters Window
To configure outbound traffic filters for a particular interface, you must first
display the Priority/Outbound Filters window for the circuit’s protocol.
Complete the following steps to display the Priority/Outbound Filters window for
an interface, enabling protocol priority if necessary.
1. In the Configuration Manager window, select Circuits➔Edit Circuits.
The Circuit List window appears.
2. Select a circuit interface.
3. Click on Edit.
The Circuit Definition window appears (Figure 7-1). If Protocol Priority
appears in the Protocols scroll box, go to Step 7.
4. Select Protocols➔Add/Delete.
The Select Protocols window appears.
5. Select Protocol Priority from the list of protocols.
The Protocol Priority option is located near the end of the list.
6. Click on OK.
The Circuit Definition window reappears.
7. Select Protocols➔Edit Protocol Priority➔Priority/Outbound Filters
(Figure 7-1).
Note: On circuits configured with Frame Relay or PPP, protocol prioritization
is enabled by default. Otherwise, you must enable Protocol Priority the first
time you configure outbound traffic filters.
Comentários a estes Manuais