Avaya BCM50 Guia de Configuração descarregar pdf (Página 521)

100

101

Chapter 70 Dial Up Interfaces panel 521

Networking Configuration Guide

Creating an automatic dial-out interface

Management applications such as SNMP trap dial out, Scheduled Log transfer, Scheduled Backup,

and Scheduled CDR records transfer can use automatic dial-out over an ISDN or Modem

interface. To configure the automatic data transfer, the administrator must configure a static route,

with the auto dial-out field selected, and associate it with the application. When data is sent to the

destination address, the network recognizes the address of the application, and triggers the dial-out

to establish the connection.The packets are then sent over the link to the destination.

Notes:

• The dial-out interface must be enabled to configure static routes.

• The disconnect time for the interface must be greater than 60 seconds. This is configured on

the Link Parameters tab of the selected interface under Configuration > Resources > Dial

Up Interfaces.

• Auto dial-out routes cannot be added if the interface is already manually connected, unless the

interface is already connected with auto dial-out routes configured.

Second dial-in IP

Address

<IP Address> The IP address that will be assigned to the BCM side of the

second dial-in connection. This is only assigned if Remote

Assigned is disabled.

Default: 10.10.18.2

Remote IP Address Specification

Assign IP address to

remote

<check box> When enabled, BCM will assign the remote end of the

connection one of the IP addresses specified below.

When cleared, the remote side will assign it’s own IP address.

Default: enabled

First dial-in IP Address <IP Address>

The IP address that will be assigned to the remote side of the

first dial-in connection. This is only assigned if Assign IP

address to remote is enabled.

Default: 10.10.18.10

Second dial-in IP

Address

The IP address that will be assigned to the remote side of the

second dial-in connection. This is only assigned if Assign IP

address to remote is enabled.

Default: 10.10.18.11

Caution: Select the Enable Dial Back-Up check box to enable Dial Back-up on

the router. Do not change the other Basic or Advanced Settings.

Table 118 ISDN Dial-In Parameters fields (Sheet 3 of 3)

Attribute Value Description

1 2 ... 516 517 518 519 520 521 522 523 524 525 526 ... 567 568

Comentários a estes Manuais

Sem comentários

Avaya BCM50 Guia de Configuração Página 521

Comentários a estes Manuais

Manuais e produtos relacionados com Software Avaya BCM50