Avaya BCM50 Guia de Configuração descarregar pdf (Página 261)

Chapter 26 Dialing plan: Routing and destination codes 261

Networking Configuration Guide

Table 47 describes the fields on the top panel.

Table 47 Route settings (Sheet 1 of 2)

Attribute Value Description

Route <001-999> This number is unique to each route.

External

Number

<a maximum of 24

digits>

Enter the external or dial-out number for the route you want the

assigned telephone to use. The external number is a digit or group

of digits that get inserted in front of your dialed digits. If all the

required numbers are defined in the destination code/dial string,

this box can be left empty.

Optional entries in the dial string:

P = 1.5 second pause (counts as one digit in the dialing string) (F78

telset)

DT = wait for dial tone (counts as two digits in the dialing string)

(F804 telset)

Use Pool Pool A to Pool O or

BlocA to BlocF

Select a line pool for the route.

The Bloc pools only display if you have PRI or VoIP trunks.

DN Type Public

Private

Local (Subscriber)

National

Special (International)

This setting tells the system what type of line protocol the route

uses to process the dial string. Refer to “PRI route types” on

page 262.

MCDN private networks: Local, National, and Special are special

designators used to route calls from Meridian 1 systems, through

BCM systems, out to the public network. Select

Configuration >

Telephony > Dialing plan > Private Networks tab to define the

codes for these settings. Also refer to “Using the MCDN access

codes to tandem calls” on page 257.

When the BCM receives outgoing calls from the Meridian 1, it

recognizes the call type and appends the appropriate access code

to the Meridian dial string.

This code then matches to a route that uses the same DN type,

passing the call along, either to another node (the route would have

the same DN type) or to the public network (the route would have a

Public DN type), depending on the routing information.

Service

Type

Public

Private

TIE

Foreign exchange

(FX)

OUTWATS

Switched Digital

(SDS)

This setting tells the system what type of line protocol the route

uses to process the dial string. These protocols are used for lines

connected to DMS-100, DMS-250 and 4ESS switches. Refer to

“PRI route types” on page 262.

Service ID <digits> If you choose a service, type in the identification number for the

service.

Note: Outgoing call display: If you have the trunks set up to send called number information,

and the DN type is set to anything, except Private, the system sends the Public OLI

number you specified under line programming. If the DN type is set to Private, the system

sends the Private OLI number. Refer to “Line Access tab” in the Device Configuration

Guide (NN40020-300).

1 2 ... 256 257 258 259 260 261 262 263 264 265 266 ... 567 568

Comentários a estes Manuais

Sem comentários

Avaya BCM50 Guia de Configuração Página 261

Comentários a estes Manuais

Manuais e produtos relacionados com Software Avaya BCM50