
300 Chapter 32 Private networking: MCDN over PRI and VoIP
NN40020-603NN40020-603
Figure 95 Message waiting indication message
Programming notes
BCM programming M1 programming
To select Remote Capability for MWI on a per-loop basis
for PRI:
Configuration > Resources > Telephony Resources >
IP Trunks > H323 Settings:
Remote Capability MWI = select (if M1 has MWI package,
with RCAP set to MWI)
1. Disable the PBX D-channel
associated with IPT (LD96).
2. Add MWI to the RCAP of the
D-channel (LD 17 RCAP
MWI)
3. Ensure the RLS ID is a
minimum of 25 (RLS ID 25).
4. Re-enabled the PBX
D-channel.
Note: Package 219 is required
on the Meridian PBX to allow
RCAP MWI.
Note: If IP routing is being used,
you must complete this
procedure on all the D-channels
in the private network.
Turning on the service for IP trunks:
Configuration > Resources > Telephony Resources >
IP Trunks > H323 Settings:
Remote Capability MWI = select (if M1 has MWI package,
with RCAP set to MWI)
Telset admin: Telco features, VMsg Ctr Tel Numbers:
• Voice Message Center 1 set to destination code plus
M1 voice mail DN
Lines (target line), Telco features:
• Configuration > Telephony > Lines > All Lines >
choose a target line to see the 'Voice message Center
1' feature under the 'Preferences' tab
Configuration > Telephony > Sets > Active sets > Line
access > Line assignment:
• assign target line to each set
• in target line, select VMsg
BCM
Meridian 1 with CallPilot
MCDN
Telephone A
Telephone B
Call forwarded to CallPilot
Original call
Message
MWI message signal (over target line)
Comentários a estes Manuais