
Chapter 70 Dial Up Interfaces panel 513
Networking Configuration Guide
Figure 142 Global Settings panel
WAN failover
The Integrated Router monitors the status of the primary WAN link. When the primary WAN link
is detected to have failed, the Integrated Router will route the traffic to the WAN Failover dial-up
interface, if one is configured. Refer to “WAN Failover Service” on page 500.
Table 115 Global Settings field
Attribute Value Description
Automatic WAN Failover
Failover interface <drop-down list> Select one of the existing dial-out interfaces that is not
selected for “Automatic dialout”. Dial-out interfaces are
provisioned from the Dial-out Interfaces tab in this same
section.
Default: -None-
Note: This parameter will not be displayed if the particular
BCM does not have the hardware to provide Failover
support.
ISDN Dial-Out Line
Pool Access
Assign a Line Pool for ISDN dial out.
Comentários a estes Manuais