Avaya BCM 2.5 IP Telephony Guia de Configuração Página 75

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 128
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 74
Chapter 4 VoIP Trunk Configuration 75
IP Telephony Configuration Guide
7 is the destination code. If a suitable level of QoS is available, the call is routed through the
VoIP trunks.
44 is the remote gateway. The call is sent across the PDN using the IP address of the Santa
Clara Business Communications Manager.
322 is linked to the target line associated with DN 322. The call arrives at the phone with the
DN 322.
If a user in Santa Clara wanted to make a local call in Ottawa, they would dial 7559 followed by
the local Ottawa number. The digit 7 accesses the VoIP line pool and 55 accesses the Ottawa
Business Communications Manager, while 9 accesses an Ottawa outside line.
Connecting an i200X telephone
This section takes the example above and uses it to demonstrate how an installer would configure
an i2004 phone on the system. For information on configuring i200X telephones, see
Chapter 3,
Installing IP Telephones, on page 31.
Connecting an i200X telephone on the LAN
In this case, the Santa Clara administrator wants to connect an i2004 phone using the LAN 1
network interface.
1 The installer sets up the Business Communications Manager to handle IP telephone by turning
Registration to ON, and Auto Assign DNs to ON.
2 The installer connects the telephone to the LAN, and sets it up using the following settings:
Set IP address:10.10.5.10
Default GW: 10.10.5.1 This is the IP address of the default gateway on the network, which
is the nearest router to the telephone.
S1 IP address: 47.62.84.1 This is the published IP address of the Business
Communications Manager.
3 The Business Communications Manager automatically assigns the telephone the DN of 348.
4 The installer sets up a target line for DN 348, using the Received Digits 348.
This phone would follow all of the same dialing rules as the other telephones on the Santa Clara
Business Communications Manager. A caller could dial 321 to connect with telephone 321, dial 9
to access the PSTN, or dial 755241 to access a telephone on the Ottawa system.
Configuring NetMeeting clients
NetMeeting is an application available from Microsoft which uses the H.323 protocol.
Note: IP clients require an IP network to reach the Business Communications
Manager. However, they do not need to use VoIP trunks to communicate beyond
the Business Communications Manager. They can use any type of trunk, just as
any other phone on the Business Communications Manager can.
Vista de página 74
1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 127 128

Comentários a estes Manuais

Sem comentários