
Starting SNMP, RMON, BootP, DHCP, and RARP Services
117362-A Rev. A 1-7
To run RMON on a Version 11.0 or later Bay Networks router, the router must
be running a Version 1.4 or later DCM image. If the router has an earlier
version of DCM, the RMON Summary application returns an error message
telling you that the router does not support RMON. For information about
upgrading your router and the DCM image, refer to Upgrading Routers from
Version 7-11.xx to Version 12.00. The upgrade guide also describes how to
determine the version of DCM you are currently running.
3. Configure an Ethernet interface for each LAN segment you want to monitor.
4. Install and configure on your network management station an RMON network
management application, such as Optivity
®
LAN or Optivity Analysis, to view
and analyze statistics generated by the Ethernet DCM.
Enabling the Ethernet DCM
The quickest way to begin using RMON is to enable a newly installed data
collection module (DCM). The DCM runs the RMON agent software that gathers
statistics for Ethernet remote monitoring support. You enable the Ethernet DCM
by creating the data collection module middleware (DCMMW) software
configuration using the default configuration parameter values. For information
about modifying the default configuration parameters, see Cha
pter 4,
“Customizing a DCM for RMON.”
To enable the Ethernet DCM from the Configuration Manager window, complete
the tasks in the following table
.
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose Platform.
The Platform menu opens.
2. Choose DCM 11.0 and later. The DCM 11.0 and Later menu opens.
(continued)
Comentários a estes Manuais