
Configuring SNMP, RMON, BootP, DHCP, and RARP Services
4-2 117362-A Rev. A
To communicate with the RMON agent software on the DCM, the router requires
a software subsystem, called DCM middleware (DCMMW). This software
subsystem enables and configures an installed DCM.
Using Site Manager or the Technician Interface, you configure the DCMMW to:
• Enable the Ethernet DCM with a default configuration (refer to Chapter 1).
• Modify the Ethernet DCM configuration.
• Boot the Ethernet DCM.
• Disable the DCM.
Modifying the DCM Configuration
You can modify the DCM configuration on an installed Ethernet DCM by
changing the DCMMW configuration parameters.
Before you can change DCMMW configuration parameters for an installed
Ethernet DCM, you must temporarily disable the Ethernet DCM from collecting
data. When you finish changing the DCMMW configuration parameters, you must
reenable the Ethernet DCM for these changes to take effect.
To modify the DCM configuration, complete the tasks in the following table.
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose Platform.
The Platform menu opens.
2. Choose DCM 11.0 and later. The DCM 11.0 and Later menu opens.
3. Choose Global ... The Global menu opens.
4. Choose the following options:
• Base Module DCM
• Expansion Module DCM
If you choose Base Module DCM, the
Edit Base Module DCM Parameters
window opens.
If you chose Expansion Module DCM for
an ARN, the Edit Expansion Module
DCM Parameters window opens, with
parameters identical to those in the Edit
Base Module DCM Parameters window.
(continued)
Comentários a estes Manuais