
Configuring Dial Services
Index-10 114062 Rev. A
Q
Q.921, 2-3
Q.931, 2-5
QMCT1
parameters
Accept Perf Measurement CR Addr, 7-30
Send Performance Measurement CR Addr,
7-30
R
R reference point description, 2-6
Raise DTR signaling
configuring lines, 7-3 to 7-11
electrical interfaces, 1-22
parameters
Cable Type, 7-10
Line Media Type, 7-10
Modem Command String, 7-11, 7-16
Priority, 7-11
WAN Serial Interface Type, 7-9
rate adaption for ISDN calls, 3-14
Redial Count parameter, 7-15
Remote Pool Type parameter, 11-11
Reserved Bandwidth Slot parameter, 10-16
retry attempts to activate backup circuit, 1-16
Retry Delay parameter, 7-15, 8-7
Retry Max parameter, 8-6
Ring Indicator parameter, 7-15
RIP Enable parameter, 8-31
Routing Information Protocol (RIP)
broadcast timers, 4-3
triggered updates, 4-3
S
S reference point description, 2-6
S/T interface, 3-8
secondary configuration
Frame Relay backup, 1-15
secondary lines
activating for bandwidth, 1-20
for congested bandwidth-on-demand circuits,
1-19
location in router slot, 1-7, 1-19
Sending IE parameter, 7-41
Service Advertising Protocol (SAP) broadcast
timers, 4-4
Service Name parameter, 9-31
service record configuration, 9-29 to 9-32
shared configuration
Frame Relay backup, 1-15
SPID parameter, 7-52
Start Time parameter, 8-21, 9-37
static routes for dial-on-demand, 4-3
Support Source CD, xxviii
switch type modifications, 7-57
Switch Type parameter, 7-39
synchronous lines
for bandwidth-on-demand, 1-18
for dial backup, 1-9
for dial-on-demand, 1-3
T
T reference point description, 2-6
terminal adapter (TA) description, 2-5
terminal equipment 1 (TE1) description, 2-5
terminal equipment 2 (TE2) description, 2-5
terminating backup circuits, 1-16
time-sensitive protocols, limitations for dial
backup, 5-2
traffic filters, 4-4
two-way authentication, 3-2
U
U reference point description, 2-6
unnumbered demand circuit groups, 5-4
Comentários a estes Manuais