Avaya Using Technician Interface Scripts Manual do Utilizador Página 52

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 892
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 51
Using Technician Interface Scripts
2-4
303560-A Rev 00
routes
Displays information from the AHB routing table.
The fields displayed have the following meanings:
VPI Indicates the virtual path of the PVC configured on the ATM
inteface. The VPI is part of the cell header, which can contain a
maximum of 8 VPI bits.
VCI Identifies the virtual channel of the PVC configured on the ATM
interface. The VCI is part of the cell header, which can contain a
maximum of 16 VCI bits.
F1 Indicates “Flags” field:
0x2= host learned dynamically
0x10=disabling forwarding to/from host
0x20= host learned in unsecure mode
TxPkts Number of packets the router transmits to the CPE host at the
remote site.
RxPkts Number of packets the router receives from the CPE host at the
remote site.
Destination Destination IP address for this route. 0.0.0.0 indicates a default
route.
Mask Subnet mask to be combined with the destination address and then
compared with the value in Destination. If the value of Destination
is 0.0.0.0 (a default route), then the value of Mask is also 0.0.0.0.
Proto Routing method through which the router learned this route: Other,
Local, Netmgmt, ICMP, EGP, GGP, Hello, RIP, IS-IS, OSPF, or
BGP.
Age Number of seconds since this route was last updated or verified to
be correct. The meaning of “too old” depends on the routing
protocol specified under Proto.
Cost Number of hops to reach the destination.
NextHop Addr/AS IP address of the next hop and next Autonomous System of this
route. If the next hop is an unnumbered interface, the command
displays 0.0.0.
n
, where
n
is the number of the circuit on which the
interface has been configured.
Vista de página 51
1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 891 892

Comentários a estes Manuais

Sem comentários