
Configuring Bridging Services
2-28 114060 Rev. A
Parameter: SR Bridge ID
Default: 0x0
Range: 0x1 to 0xf
Function: Specifies this bridge’s bridge ID and identifies the Bay Networks source
routing bridges in the network.
Instructions: Assign the same bridge ID to all Bay Networks source routing bridges in
the network (unless two bridges operate in parallel; see note below). The
bridge ID must be unique among any other non-Bay Networks bridge IDs
in the network.
You cannot use the value 0x0 that appears initially in the parameter box.
You must specify a value for this parameter that is within the given range.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.1.2.1.5
3. When you have configured the required parameters in the Edit Source
Routing Global Parameters window, click on OK.
The SR Interface List window appears (Figure
2-15).
4. Specify the source routing ring number, using the description that follows
as a guide, and click on OK.
Note: If two Bay Networks source routing bridges operate in parallel, you
must assign a different SR bridge ID to one of the bridges. You must also
specify the SR bridge ID in the Bridge Entry list for all other Bay Networks
source routing bridges in the network. (See “Implementation Notes” for more
information.)
Comentários a estes Manuais