
Configuring Bridging Services
2-42 114060 Rev. A
Parameter: Inbound STEs
Default: Accept
Options: Accept
| Block
Function: Specifies whether the bridge should drop single route explorer frames
received on this circuit. This option will not stop single route explorer
frames from being transmitted on this circuit. This parameter has no effect
if you configure this interface with the Source Routing Spanning Tree
protocol.
Instructions: Set to Block only if you want spanning tree explorer packets to be
dropped by this circuit.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.1.2.2.1.8
Parameter: Frames with IP Ring
Default: Accept
Options: Accept
| Block
Function: Specifies whether the bridge should block inbound explorer frames
received on this circuit that traversed the IP network via IP encapsulation.
Instructions: Set to Block only if you want to limit the route selection possibilities
using IP encapsulation.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.1.2.2.1.9
Comentários a estes Manuais