
Configuring Bridging Services
4-12 114060 Rev. A
Remember that the spanning tree algorithm works only if you use Token Ring
interfaces to the SR network. If you use a different kind of interface to the SR
network, you must use another method to eliminate loops. (Refer to the
previous section, “Loop-Free Operation
,” for details on methods for
eliminating loops.)
6. Set the spanning tree’s Translation Bridge Enable parameter to Enable
for all Token Ring SR interfaces on which you enabled spanning tree.
Enabling Source Routing Translate/LB Service
To enable Translate/LB on an interface, complete the following steps:
1. From the Select Protocols menu, select the Translate/LB option that is
directly under the Source Routing option.
Note that the Configuration Manager also selects the Source Routing option,
because the Translate/Learning Bridge protocol cannot run without source
routing enabled.
The Edit Translation Bridge Global Parameters window appears (Figure 4-3).
2. Configure the Virtual LAN ID parameter and click on OK.
Use the description that follows as a guide.
If you have not yet enabled source routing on any circuit, the Edit Source
Routing Global Parameters window appears (Figure
2-14). If you have
enabled source routing on some other circuit, the SR Interface List window
appears (Figure
2-15).
Refer to “
Enabling Source Routing Services on an Interface” in Chapter 2 to
configure the necessary source routing parameters.
Comentários a estes Manuais