Avaya Using Technician Interface Software Manual do Utilizador descarregar pdf (Página 333)

Using Syslog Messaging to Monitor Router

114088 Rev. A C-25

Re-enable an entity ﬁlter by entering the following command line:

$: set wfSyslogEntFltrEntry.wfSyslogEntFltrDisable.

<wfSyslogEntFltrHostIndex>.<wfSyslogEntFltrNum>.

1;commit

Re-enabling a ﬁlter

• Transitions the operational state of that ﬁlter

(wfSyslogHostOperState) to ACTIVE

• Allows Syslog to resume forwarding event messages through that

ﬁlter

Deleting Remote Hosts or Entity Filters from the Syslog Conﬁguration

You can delete a remote host from the Syslog host table, or delete a ﬁlter from the

Syslog ﬁlter table, as follows:

1. If you want to delete a remote host entry from the Syslog host table, enter

the following command line:

$: set wfSyslogHostEntry.wfSyslogHostDelete.

2;commit

If you want to delete a ﬁlter from the Syslog Entity Filter table, enter the

following command line:

$: set

wfSyslogEntFltrEntry.wfSyslogEntFltrDelete.

<wfSyslogEntFltrHostIndex>.

2;commit

Save the changes to your conﬁguration. (Refer to Task 8, earlier in this

appendix.)

Deleting Syslog from the Router

If you want to delete Syslog from the router, change the setting for

wfSyslogDelete, a global parameter/attribute, as follows:

$:set wfSyslog.wfSyslogDelete.0 2;commit

1 2 ... 328 329 330 331 332 333 334 335 336 337 338 ... 365 366

Sem comentários

Avaya Using Technician Interface Software Manual do Utilizador Página 333