Avaya Using Technician Interface Software Manual do Utilizador descarregar pdf (Página 325)

Using Syslog Messaging to Monitor Router

114088 Rev. A C-17

Conﬁgure the maximum number of active hosts served by Syslog on the

router:

$: set wfSyslog.wfSyslogMaxHosts.0

<1 - 10>

;commit

The default setting for wfSyslogMaxHosts is 5 hosts. You can add to the

Syslog Host Table more entries than the conﬁgured maximum, but Syslog

forwards messages only to the ﬁrst “n” active hosts, where n = the current

value of wfSyslogMaxHosts.

2. Conﬁgure the interval (in seconds) between Syslog polling cycles on the

router:

$: set wfSyslog.wfSyslogPollTimer.0

<5 - 610000>

;commit

The default setting for wfSyslogPollTimer is 5 seconds.

Next, add a remote host to the Syslog Host Table.

Task 5: Adding a Remote Host to the Syslog Host Table

You must deﬁne any remote hosts that you want to receive Syslog (event)

messages from routers in your network.

If this is the ﬁrst host you are adding to the Syslog host table, go to Step 1.

Otherwise, you may want to ﬁrst obtain a list of hosts already conﬁgured on the

router. To list existing entries in the Syslog host table, enter the following

command at the Technician Interface prompt:

list -i wfSyslogHostEntry

The list includes the instance IDs (in this case, the IP addresses) of all remote

hosts currently deﬁned in the Syslog host table.

1. Add a new host entry to the Syslog Host Table, as follows:

$: set wfSyslogHostTable.wfSyslogHostDelete.

<host_IP_address>

$: commit

This entry informs Syslog of a remote host at the destination IP address that

you speciﬁed.

If you want to accept the default settings for host attributes

wfSyslogHostLogFacility (184 = Local7) and wfSyslogHostTimeSeqEnable

(2 = disabled), go to Task 6. Otherwise, continue with Step 2 to conﬁgure a

customized setting for either attribute.

1 2 ... 320 321 322 323 324 325 326 327 328 329 330 ... 365 366

Sem comentários

Avaya Using Technician Interface Software Manual do Utilizador Página 325