Avaya Configuring TDM Services Manual do Utilizador descarregar pdf (Página 26)

Configuring TDM Services

2-6

309426-14.10 Rev 01

Making a CES H.110 TDM Circuit Connection

You can set the circuit type to CES H.110 if you want to connect a dual

synchronous port with an ATM PVC on an ATM T1/E1 port so that you can

emulate TDM functionality over ATM using CES. This type of circuit enables you

to connect video conferencing equipment in two different remote locations.

To connect both ends of a CES H.110 TDM circuit, complete the following steps:

• Create an entry for the dual synchronous connector.

• Create an entry for the ATM connector.

• Define an ATM PVC service record that uses null encapsulation.

• Create an ATM PVC that uses AAL 1 encapsulation and uses the CBR service

category.

• Start CES to connect the dual synchronous connector to the ATM PVC.

Using the BCC

Create an entry for the dual synchronous connector.

To make a CES H.110 TDM circuit connection, first navigate to the box

prompt (for example,

box#

) and enter:

dsync

slot

<slot_number>

pci-slot

<pci_number>

module

<mod_number>

connector

<connector_number>

slot_number

is the slot number containing the dual synchronous module. The

slot number for the dual synchronous module is always 1.

pci_number

is the number of the pci-slot containing the dual synchronous

board.

module_number

is a convention used within the Passport 5430 chassis.

connector_number

is the connector associated with this interface.

Note:

Once you connect the PORT connector to the other end of the circuit,

you cannot modify the circuit type. To modify the circuit type, you must first

disconnect the port.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 57 58

Comentários a estes Manuais

Sem comentários

Avaya Configuring TDM Services Manual do Utilizador Página 26

Comentários a estes Manuais

Manuais e produtos relacionados com Software Avaya Configuring TDM Services