
Configuring IP Exterior Gateway Protocols (BGP and EGP)
5-20
308628-14.00 Rev 00
Using Site Manager
Disabling and Reenabling the BGP-4 MED Attribute
By default, BGP-4 considers the multiexit discriminator (MED) attribute in the
route selection process (see Table 1-2 on page 1-9
).
You can use the BCC or Site Manager to configure BGP-4 so that it disregards the
MED attribute in the route selection process.
Using the BCC
Navigate to the BGP prompt and enter:
med-comparison
<
state>
state
is one of the following:
enabled
(default)
disabled
For example, the following command causes BGP-4 to disregard the MED
attribute in an update when selecting a route:
/jointfilesconvert/106988/bgp#
med-comparison disabled
/jointfilesconvert/106988/bgp#
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose
Protocols
.
The Protocols menu opens.
2. Choose
IP
. The IP menu opens.
3. Choose
BGP
. The BGP menu opens.
4. Choose
BGP Global
. The Edit BGP Global Parameters window
opens.
5. Set the
Black Hole Routes
parameter.
Click on
Help
or see the parameter
description on page A-7
.
6. Click on
OK
. Site Manager returns you to the
Configuration Manager window.
Comentários a estes Manuais