Avaya Configuring DLSw Services Manual do Utilizador descarregar pdf (Página 63)

DLSw Configuration Overview

3-7

If a unique IP address is not available, you must perform one of the following

tasks:

• For conﬁgurations that do not have as many physical IP interfaces as DLSw

slots, add multiple IP addresses to a single physical interface. For example,

you might want to do this in large SDLC conﬁgurations, since IP cannot be

conﬁgured on SDLC interfaces. For more information on conﬁguring multiple

IP addresses, see Conﬁguring IP Services.

• For single switch operation, enter any valid IP address that is available but not

used in your network. This address should be on a unique IP subnet.

Figure 3-4 shows a sample network with three routers running DLSw. Although

many options exist for the Slot Table, this network uses the following values in the

Slot Tables:

• Router A, the central site router, has three slots running DLSw, as follows:

— For Slot 1, the circuitless IP address is used in the Slot Table to represent

this slot. This provides the highest availability for Token Ring devices.

— For Slot 3, the IP address of the directly attached Frame Relay interface

represents this slot in the Slot Table.

— For Slot 4, note that an IP address cannot be assigned to an SDLC

interface, and no IP address is assigned to the Frame Relay interface.

Instead, the IP address of a Token Ring interface on Slot 1 is used in the

Slot Table. It is acceptable to use any other IP address existing on this

router to represent this slot.

• Router B, a remote site connected to the central site using Frame Relay, is a

single slot router running single switch DLSw. The IP address of the Frame

Relay interface represents this slot in the Slot Table.

Note: You can use the circuitless IP interface address for one (and only one)

DLSw-capable slot. Using the circuitless IP interface allows TCP connections

for DLSw services on that slot to be less dependent on the availability of

speciﬁc physical circuits or data links. We recommend that you set the

Keepalive Time parameter to a nonzero value when using the circuitless IP

address. (For more information on the circuitless IP interface, refer to

Conﬁguring IP Services.)

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 203 204

Sem comentários

Avaya Configuring DLSw Services Manual do Utilizador Página 63