
GeoTel Features User Manual NCD Alarm Messages
P0602482 Ver. 04.03 Avaya Page 439
Temperature for TMS in slot # is out of tolerance,
detecting temperature above high temperature threshold
• The displayed TMS has exceeded the second temperature threshold.
Operating the system at these temperatures may cause permanent component
damage. Shut down the system. See “Temperature” on page 442.
TMS in slot %d failed to load software image
• The displayed TMS is having problems loading. The NIC has detected a TMS
in one of the backplane slots but the TMS does not fully boot and establish a
health check with the NIC. See TMS Initialization on page 443 and TMS
Health Check on page 443.
The following messages indicate that the previous error conditions are clearing/have
cleared
Clearing Hardware Health check failure for TMS in slot #
Clearing Ethernet Health check failure for TMS in slot #
Clearing Power supply temperature alarm for TMS in slot #
Clearing Power supply current C1(21 amps) alarm for TMS
in slot #
Clearing Power supply current C2(31 amps) alarm for TMS
in slot #
Clearing Power supply current C3(9 amps) alarm for TMS in
slot #
Clearing Power supply current C4(1 amp) alarm for TMS in
slot #
Clearing Power supply voltage V1(3 volts) alarm for TMS
in slot #
Clearing Power supply voltage V2(5 volts) alarm for TMS
in slot #
Clearing Power supply voltage V3(12 volts) alarm for TMS
in slot #
Clearing Power supply voltage V4(-12 volts) alarm for TMS
in slot #
Clearing alarm for TMS Temperature in slot #
Comentários a estes Manuais