
Configuring Traffic Filters and Protocol Prioritization
7-2
303543-A Rev 00
Displaying the Priority/Outbound Filters Window
You must complete the following tasks to configure outbound traffic filters on an
interface:
• Add the Protocol Priority protocol if it is not already enabled.
On circuits configured with Frame Relay or PPP, protocol prioritization is
enabled by default. Otherwise, you must enable protocol prioritization the
first time you configure outbound traffic filters.
• Display the Configuration Manager Priority/Outbound Filters window.
To display the Priority/Outbound Filters window and, if necessary, enable
protocol prioritization:
Site Manager Procedure
You do this System responds
1. Display the Configuration Manager
window.
2. Click on the circuit interface connector (for
example,
COM1
,
XCVR2
).
For Ethernet, FDDI, HSSI, synchronous,
or token ring interfaces, the Edit
Connector window opens.
For MCE1 or MCT1 interfaces, the
Logical Lines window opens.
3. Click on
Edit Circuit
; or, for MCE1/MCT1,
click on
Circuit
.
The Circuit Definition window opens; the
circuit you selected is highlighted.
4. If Protocol Priority appears in the
Protocols field, go to step 7
; otherwise,
choose Protocols > Add/Delete.
The Select Protocols window opens.
5. Select Protocol Priority from the list of
protocols.
The Protocol Priority option is located near the
bottom of the list.
6. Click on
OK
. The Circuit Definition window opens
(Figure 7-1)
.
7. Choose Protocols > Edit Protocol Priority
> Priority/Outbound Filters.
The Priority/Outbound Filters window
opens (Figure 7-2)
.
Comentários a estes Manuais