
114084 Rev. A 4-1
Chapter 4
Configuring Network Booting
This chapter describes how to use Site Manager to configure network booting for
AN, ANH, or ARN routers in the network.You can also use Technician Interface
commands to configure network booting, as described in Chapter 5.
The following sections of this chapter explain how to complete the tasks required
for configuring EZ-Install, Netboot, or Directed Netboot.
Note: Before the router can get files over the network, you must also set up a
UNIX BOOTP server on the network, as described in Chapter 3.
To Configure This Boot Method Complete These Sections of this Chapter
EZ-Install Preparing Configuration and Image Files
EZ-Install over Frame Relay
group-access PVC
• Preparing Configuration and Image Files
• Creating the BOOTP Client Interface Table
Netboot • Enabling Netboot or Directed Netboot from
Site Manager
• Configuring a Netboot or Directed Netboot
Interface
• Setting Up Routing Paths for Netboot
Directed Netboot • Enabling Netboot or Directed Netboot from
Site Manager
• Configuring a Netboot or Directed Netboot
Interface
Note: The steps in this chapter assume that the Site Manager software is
running on a network workstation.
Comentários a estes Manuais