
Configuring Remote Access
5-8 114084 Rev. A
Table 5-5 describes the ifconfig command arguments for enabling and disabling
interfaces for network booting.
ifconfig Command Examples
1. Configure the current interface for the default Netboot procedure.
ifconfig -d
2. Specify the IP address and subnet mask of the first Ethernet Netboot interface.
ifconfig xcvr1 21.3.5.62 255.255.255.0
3. Specify the IP address and subnet mask of the second Ethernet Netboot
interface.
ifconfig xcvr2 21.3.5.61 255.255.255.0
4. Configure the IP address and Frame Relay DLCMI of the third synchronous
Netboot interface.
ifconfig com3 21.3.5.62 -fr -annexa
5. Specify the IP address and subnet mask of the first Token Ring interface on an
ARN.
ifconfig mau1 21.3.4.77 255.255.255.0
Table 5-5. ifconfig Settings to Enable and Disable Netboot Interfaces
Setting Description
<
interface>
Specifies the IP connector you are enabling or disabling for network
booting. Use one of the following formats:
xcvr
<port no.>
com
<port no.>
mau
<port no.>
Comentários a estes Manuais