Avaya Configuring IP, ARP, RARP, RIP, and OSPF Services Manual do Utilizador descarregar pdf (Página 292)

Configuring IP, ARP, RARP, RIP, and OSPF Services

A-30

308627-14.20 Rev 00

Adjacent Host Parameters

Parameter: Enable

Path: Configuration Manager > Protocols > IP > Adjacent Hosts

Default: Enable

Options: Enable

Disable

Function: Specifies the state (active or inactive) of the adjacent host in the IP routing

tables.

Instructions: Select Disable to make the adjacent host record inactive in the IP routing table;

the IP router will not consider this adjacent host. Select Enable to make the

adjacent host record active again in the IP routing table.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.6.1.2

Parameter: IP Adjacent Host Address

Path: Configuration Manager > Protocols > IP > Adjacent Hosts > Add

Default: None

Options: Any valid IP address

Function: Specifies the IP address of the device for which you want to configure an

adjacent host.

Instructions: Enter the IP address in dotted-decimal notation.

MIB Object ID: Not applicable

Parameter: Adjacent Host Address

Path: Configuration Manager > Protocols > IP > Adjacent Hosts

Default: None

Options: Any valid IP address or X.121 address (X.25 only)

Function: Specifies the address of the adjacent host. This address is required for protocols

that cannot perform address resolution.

Instructions: Enter the address of the adjacent host. If you configured X.25 as the data link

protocol, and the connection type is PDN/X.25, DDN/X.25, or BFE/PVCs,

enter the X.121 address of the remote PVC.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.6.1.9

1 2 ... 287 288 289 290 291 292 293 294 295 296 297 ... 389 390

Sem comentários

Avaya Configuring IP, ARP, RARP, RIP, and OSPF Services Manual do Utilizador Página 292