Avaya Configuring Dial Services Manual do Utilizador descarregar pdf (Página 179)

100

101

Customizing Line Pools

308621-14.00 Rev 00

9-5

Specifying the Asynchronous Modem Control Character Map

If you are using asynchronous PPP and asychronous modems, you may want to

set up asynchronous modem control characters. During LCP negotiations, the

peers negotiate the characters that they will recognize as asynchronous modem

control characters. PPP creates a 32-bit map that represents the negotiated control

characters. Both routers use this map in sending and receiving data packets.

Although the default value serves for almost all modems, you can configure the

map for other modem control characters if necessary.

The async control character map specifies a value representing one or more

asynchronous modem control characters for the peer to recognize (“escape”) and

that may occur in the data packet. Each bit in the map corresponds to one control

character, 0x00 (the right end of the map) through 0x1f (the left end of the map);

that is, 0 through 31, decimal. The actual map is a value used essentially as a

mask. For example, the default map value, 0xa0000 (655360 decimal) allows the

escaping of the control characters 0x11 (XON) and 0x13 (XOFF) if they occur in

the data stream. The values 0x7d and 0x7e are always escaped.

If you have a modem that requires control characters different from the default,

you can build your own async control character map. Determine the

corresponding bit for each character by converting the hexadecimal value of the

control character to decimal. For example, 0x1f = 31 decimal; to escape that

character, set the leftmost bit in the map. Do the same thing for each control

character. After you decide what bits in the map to set, you can enter either the

hex character equivalent to the bit string or the decimal equivalent. To escape all

control characters in the packet, set the map to 0xffffffff. For a description of how

PPP encodes escaped control characters in the data stream, see Configuring PPP

Services.

PPP displays the decimal number equivalent to the string and uses that value in its

link negotiations.

To set the async control character map, navigate to the dial prompt and enter:

accm-seed

integer

is a number from 0 to 4,294,967,295 (0x00 through 0xFFFFFFFF).

For example:

dial/bri/1/1#

accm-seed 755300

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 551 552

Comentários a estes Manuais

Sem comentários

Avaya Configuring Dial Services Manual do Utilizador Página 179

Comentários a estes Manuais

Manuais e produtos relacionados com Manuais de software Avaya Configuring Dial Services