Avaya Configuring BayStack Remote Access Manual do Utilizador descarregar pdf (Página 78)

Configuring BayStack Remote Access

4-10

308614-14.00 Rev 00

Verifying Your Configuration

You can use the

getcfg

command to verify the following:

• Whether the router is set to boot using a local or remote boot image

• Whether the router is set to configure using a local or remote configuration

file

• The configuration of the serial, Ethernet, and token ring (ARN only)

interfaces

To display the configured startup options for a BayStack router, enter the

following command at the Technician Interface or AN Monitor prompt:

getcfg

The following sample output shows the default configuration for an AN/ANH

with one Ethernet interface and two serial interfaces:

Boot Options

boot image=local

boot config=network

Netboot Parameters:

XCVR1..None

COM1...EZ-Install

COM2...EZ-Install

The following sample output shows the configuration for an ARN with one

Ethernet interface, one token ring interface, and five serial interfaces:

Boot Options

boot image=local

boot config=network

Netboot Parameters:

MAU1...None

XCVR2..None

COM1...EZ-Install

COM2...EZ-Install

COM3...EZ-Install

COM4...EZ-Install

COM5...EZ-Install

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 139 140

Sem comentários

Avaya Configuring BayStack Remote Access Manual do Utilizador Página 78