Avaya Configuring BayStack Remote Access Manual do Utilizador descarregar pdf (Página 107)

Troubleshooting Network Boot Problems

308614-14.00 Rev 00

B-11

The following sample response shows the default settings for an AN/ANH with

one Ethernet interface and two synchronous interfaces:

Boot Options

boot image=local

boot config=network

Netboot Parameters:

XCVR1..None

COM1...EZ-Install

COM2...EZ-Install

The following sample response shows the settings for an ARN with one Ethernet

interface, one token ring interface, and five synchronous interfaces:

Boot Options

boot image=local

boot config=network

Netboot Parameters:

MAU1...None

XCVR2..None

COM1...EZ-Install

COM2...EZ-Install

COM3...EZ-Install

COM4...EZ-Install

COM5...EZ-Install

The possible settings for boot image and boot config are network and local. If

the setting is

network, the BayStack router requests the kernel file or

configuration file from a BootP server when booting. If the setting is

local, the

BayStack router uses the kernel file or configuration file stored in flash memory.

The

XCVR parameter shows the current setting of the Ethernet connectors. The COM

parameters show the current settings of the synchronous connectors. The MAU

parameter shows the setting of the token ring connectors (ARN only).

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 139 140

Sem comentários

Avaya Configuring BayStack Remote Access Manual do Utilizador Página 107