Avaya Configuring BayStack Remote Access Manual do Utilizador descarregar pdf (Página 129)

Using the Quick-Start Local Boot Procedure

308614-14.00 Rev 00

C-13

Running the Quick-Start Script

To quick-start a BayStack router, you run the install.bat (AN/ANH) or

inst_arn.bat (ARN) Technician Interface script, and respond to the prompts. The

router automatically selects options for some prompts, and you can accept default

values for many of the other prompts. You run the script as part of the Local Boot

process.

To perform the Quick-Start procedure:

Make sure that you have the completed worksheets with you.

Start the BayStack router.

At the Technician Interface prompt, enter

Manager

to log in.

The Technician Interface mounts the local file system and displays the

command-line prompt.

To ensure that the BayStack router is using the configuration file (

config

)

on the local flash memory card, issue the

getcfg

command.

Look for the following line in the

getcfg command display:

boot config = local

SMDS Worksheet

Requested Information Options Your Response

Enter 10-digit individual

address:

Enter the individual address

assigned by your SMDS service

provider.

Enter 10-digit group address: Enter the group address assigned

by your SMDS service provider.

Enter 10-digit arp address: Enter the Address Resolution

Protocol (ARP) address assigned

by your SMDS service provider.

Note:

Manager is case-sensitive; use an uppercase M.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 139 140

Sem comentários

Avaya Configuring BayStack Remote Access Manual do Utilizador Página 129