Avaya Configuring BayStack Remote Access Manual do Utilizador descarregar pdf (Página 39)

Understanding Tools and Options

308614-14.00 Rev 00

1-21

Directed Netboot

Complete the following steps for the Directed Netboot option:

Use the Configuration Manager in local mode to create a complete

configuration file for the BayStack router. (See Chapter 3 and Configuring

and Managing Routers with Site Manager.)

Set up a network server to support TFTP. (See Chapter 2.)

Install the BayStack router image and/or configuration files in the TFTP

server’s file system. (See Chapter 2.)

Ensure that there is a network connection from a synchronous, Ethernet, or

token ring (ARN only) interface on the BayStack router to the upstream

router.

The person at the BayStack router site establishes a Technician Interface

session, or you establish a session using a modem. (See the hardware

installation guide.)

The person at the BayStack router console uses the

bconfig

and

ifconfig

commands to configure a synchronous, Ethernet, or token ring (ARN only)

interface. (See Chapter 4 and the hardware installation guide.)

The person at the BayStack router site boots the router. (See the hardware

installation guide.)

The BayStack router obtains one or more startup files from the TFTP server.

If the configuration file meets your network requirements, the BayStack

router starts bridging and routing traffic.

Use the Site Manager Statistics Manager and Events Manager tools to verify

that the BayStack router is routing traffic as specified in the configuration file.

(See Configuring and Managing Routers with Site Manager.)

Note:

If the BayStack router will connect to the upstream router over a frame

relay circuit, ensure that the upstream router is running BayRS Version 8.00 or

later.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 139 140

Sem comentários

Avaya Configuring BayStack Remote Access Manual do Utilizador Página 39