
Configuring SDLC Services
4-18 114053 Rev. A
Parameter: Link Station Address (hex)
Default: None
Options: Any valid hexadecimal link station address from 0x01 to 0xFE
Function: Specifies the address of the link station.
Instructions: Type 0x followed by the link station address.
MIB Object ID: None
Editing SDLC Link Station Parameters
To edit SDLC link station parameters, complete the following steps. If you just
completed the procedure in “Adding an SDLC Link Station,” go to Step 3.
1. In the Configuration Manager window (refer to Figure 4-1), select
Protocols > SDLC > Link Stations.
The SDLC Link Station Configuration window appears (refer to Figure 4-4).
2. Select the address of the link station.
3. Edit the link station parameter values.
For information, refer to the parameter descriptions in the next section.
4. Click on Apply to save your changes.
5. Click on Done to exit.
Comentários a estes Manuais