
114053 Rev. A 3-1
Chapter 3
Enabling SDLC Services
This chapter describes how to enable SDLC services. It assumes you have read
Configuring Routers and
1. Opened a configuration file.
2. Specified router hardware if this is a local-mode configuration file.
3. Selected the connector on which you are enabling SDLC, labeled either
COM1, COM2, or MCT1.
When you enable SDLC services, you are required to specify only a few
parameters. The Configuration Manager supplies default values for the rest. If you
want to edit these parameters, see Chapter 4.
Enabling SDLC on an Interface
To enable SDLC on an interface:
1. Select SDLC in the WAN Protocols window.
The Configuration Manager displays the SDLC Line Parameters window
(Figure 3-1).
Comentários a estes Manuais