Avaya Configuring PPP Services Manual do Utilizador Página 71

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 118
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 70
Customizing PPP
114068 Rev. A 3-19
If two routers are configured for different link quality reporting periods, they
negotiate to the lower value, so that the period is the same on both sides of the
link.
Enabling Link Quality Monitoring and Reporting
To turn on link quality monitoring and reporting for the interface, set the Link
Quality Protocol parameter to LINKQR.
When you enable link quality monitoring and reporting through the link quality
protocol, you are turning on monitoring only for the local router. The router on
which you enable it is responsible for monitoring link quality for the connection.
By default, link quality monitoring and reporting is disabled.
If you do not enable link quality monitoring and reporting, ignore the rest of the
link quality parameters.
Establishing the Timing of Link Quality Reports
You can specify which peer is responsible for running the Link Quality Report
Timer and set the maximum interval between the transmission of Link Quality
Report packets.
Designating the Link Quality Report Timekeeper
This parameter deals with the remote peer, not the local one. The setting
determines whether the remote peer runs the Link Quality Report (LQR) timer for
the connection. Setting this parameter enables or disables the remote peer’s LQR
timer.
Note: PPP supports link quality monitoring over standard synchronous
interfaces only. PPP does not support link quality monitoring over
asynchronous or High-Speed Serial Interfaces (HSSI). BNX software,
however, does support both link quality monitoring and link quality reporting
over HSSI interfaces.
Site Manager: Link Quality Protocol parameter: page A-20
Vista de página 70
1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 117 118

Comentários a estes Manuais

Sem comentários