Avaya Configuring PPP Services Manual do Utilizador Página 35

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 118
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 34
PPP Concepts
114068 Rev. A 2-9
Figure 2-3. PPP-Encapsulated Frame
The parts of the PPP frame function as follows:
The Flag field marks the beginning and end of a frame. Peers on synchronous
lines exchange flags continuously when there are no frames to transmit.
The Address field indicates which device originated the frame.
The Control field shows the frame type (information or administrative).
The Protocol field indicates the operative network layer protocol.
The Data field contains the data one link sends to the other. Its length is less
than or equal to the MTU line size. The default maximum length is 1594
bytes; LCP negotiations determine the actual length.
The Frame Check Sequence (FCS) field shows the sequence order of the
frame; router hardware computes the FCS. A 16- or 32-bit cyclic redundancy
check (CRC) is at the end of each frame.
PPP Dial Services Support
Bay Networks dial services offer access to switched networks through dial-up line
connections (also called switched lines) that are active only when you choose to
use them. In contrast, a leased line is always available. If you transmit limited
amounts of data, or if your data transmission is intermittent, dial services may let
you run your network more effectively and economically.
PPP is automatically configured on lines that you select for dial services. PPP,
with either CHAP or PAP, implements a router identification mechanism that dial
services require.
PPP 0003A
PPP Frame
Flag
Address Control Protocol
Data
FCS Flag
1 byte 1 byte 1 byte1 byte 2 bytes Variable 2 or 4
bytes
Vista de página 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 117 118

Comentários a estes Manuais

Sem comentários