Avaya Configuring DECnet Services Manual do Utilizador descarregar pdf (Página 65)

Editing DECnet Parameters

308619-14.00 Rev 00

3-27

Click on OK to exit the window and save your changes.

The DECnet Static Adjacent Hosts List window reappears. The static

adjacency you configured is displayed in the list.

Repeat steps 4 through 6 to add additional static adjacencies.

DECnet Static Adjacency Parameter Descriptions

Use the following descriptions as a guide when you configure the parameters in

the DECnet Static Adjacent Hosts List window (refer to Figure 3-8

) and the

DECnet Static Adjacency Configuration window (refer to Figure 3-9

Parameter: Adjacency Enable

Default: Enable

Options: Enable

Disable

Function: Specifies the state of the static adjacency record in the DECnet router’s

routing tables.

Instructions: Select Disable to make the static adjacency record inactive in the DECnet

routing table; the router will not consider this static adjacency.

Select Enable to make this static adjacency record active again.

This parameter defaults to Enable when you click on Add in the DECnet

Static Adjacent Hosts List window.

MIB Object ID: 1.3.6.1.4.1.18.3.5.2.7.2

Parameter: Adjacency Type

Default: Area

Options: Area

Routing IV

Non-Routing IV

Function: Specifies whether the static adjacency is another router or an end node.

Instructions: Select Area if the static adjacency is a Level 2 router, select Routing IV if

the static adjacency is a Level 1 router, or select Non-Routing IV if the

static adjacency is an end node.

MIB Object ID: 1.3.6.1.4.1.18.3.5.2.7.7

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 79 80

Sem comentários

Avaya Configuring DECnet Services Manual do Utilizador Página 65