
308619-14.00 Rev 00
2-1
Chapter 2
Enabling DECnet Services
This chapter describes how to enable DECnet Phase IV services. It assumes you
have read Configuring Routers and that you have:
1.
Opened a configuration file
2.
Specified router hardware if this is a local mode configuration file
3.
Selected the link- or net-module connector on which you are enabling
DECnet Phase IV, or configured a WAN circuit if this connector requires
one
When you enable DECnet services, you are required to specify only a few
parameters. The Configuration Manager supplies default values for the remaining
parameters. If you want to edit these default values, refer to Chapter 3, “Editing
DECnet Parameters.”
For each DECnet parameter, this guide provides the default setting, valid
parameter options, the parameter function, instructions for setting the parameter,
and the management information base (MIB) object ID.
Note:
Although you can accept the default values for most DECnet
parameters, we recommend that you try to tune your DECnet configuration to
closely match your actual configuration. Typically, when you customize the
parameters, DECnet uses less local memory, enhancing DECnet performance.
Comentários a estes Manuais