Avaya Configuring DECnet Services Manual do Utilizador descarregar pdf (Página 36)

Configuring DECnet Services

2-2

308619-14.00 Rev 00

The Technician Interface lets you modify parameters by issuing set and commit

commands that specify the MIB object ID. This process is equivalent to

modifying parameters using Site Manager. For more information about using the

Technician Interface to access the MIB, refer to Using Technician Interface

Software.

Enabling DECnet Phase IV on an Interface

To enable DECnet Phase IV on an interface:

Select DECnet from the Select Protocols menu.

The Select Protocols menu appears after you either select a link- or

net-module connector, or finish configuring a WAN circuit.

The DECnet IV Configuration window appears (Figure 2-1)

Figure 2-1. DECnet IV Configuration Window

Configure the parameters using the descriptions that follow as a guide.

When you finish configuring the parameters, click on OK.

To edit the default values for DECnet parameters, refer to Chapter 3 for

instructions.

Caution:

The Technician Interface does not verify that the value you enter for

a parameter is valid. Entering an invalid value can corrupt your configuration.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 79 80

Sem comentários

Avaya Configuring DECnet Services Manual do Utilizador Página 36