Avaya Configuring ATM Services Manual do Utilizador descarregar pdf (Página 161)

Editing ATM Service and Interface Parameters

8-7

Adding a Service Record for SVCs

To add a service record for switched virtual circuits:

1. Click on Service Attributes in the Edit ATM Connector window (refer to

Figure 8-1).

The ATM Service Records List window opens (refer to Figure 8-2).

2. Click on Add.

The ATM Service Record Parameters window opens (refer to Figure 8-3). If

you want to change any of the parameters in the ATM Service Record

Parameters window, refer to “ATM Service Record Parameter Descriptions,”

later in this chapter, for instructions.

3. Click on OK.

The Select Protocols window opens.

4. Click on the protocols you want to enable.

5. Click on OK.

For each protocol you select, the Conﬁguration Manager displays a protocol-

speciﬁc window prompting you for required information. If you need

assistance in responding to any queries, consult the appropriate protocol-

speciﬁc guide.

When you ﬁnish conﬁguring the protocols, the Conﬁguration Manager returns

you to the ATM Service Records List window.

Note: The contents of the Select Protocols window vary, depending on the

data encapsulation type you set in the ATM Service Record Parameters

window. Refer to “Assigning Data Encapsulation” in Chapter 7 for additional

information.

1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 309 310

Sem comentários

Avaya Configuring ATM Services Manual do Utilizador Página 161