Avaya B5800 Manual do Utilizador descarregar pdf (Página 211)

About changing components

Except for memory cards, cards and external expansions modules must only be removed and

added to an B5800 Branch Gateway system when the system is turned off. See

Memory card

removal on page 261 and System shutdown on page 208 for more information.

Note that for extension ports, by default both an extension entry and a user entry are configured

in the system. Extension entries can be deleted without deleting the corresponding user entry.

This allows retention of the user settings and association of the user with a different extension

by changing that extension's Base Extension number to match the user's Extension ID.

In the following procedures, the term component refers to a card fitted into the control unit or

an external expansion module.

Replacing a component with one of the same type

About this task

If you are replacing a component with one of the same type and capacity, no configuration

changes are required.

Procedure

1. Turn the B5800 Branch Gateway system off. See System shutdown on page 208.

2. Remove the card or external expansion module.

Note:

The card slot or expansion port used as the replacement must be installed in the

same position.

3. Install the replacement using the appropriate procedure for the type of component.

See

Base and trunk card installation on page 61 or Connecting external expansion

modules on page 72 for more information.

4. Restart the B5800 Branch Gateway system.

About changing components

Implementing B5800 Branch Gateway for a CS 1000 Configuration October 2012 211

1 2 ... 206 207 208 209 210 211 212 213 214 215 216 ... 323 324

Sem comentários

Avaya B5800 Manual do Utilizador Página 211