Avaya B5800 Manual do Utilizador descarregar pdf (Página 135)

Disabling unused trunks

About this task

Each B5800 Branch Gateway trunk card provides a fixed number of trunk ports with digital

trunk ports supporting a fixed number of digital channels. By default the B5800 Branch

Gateway configuration will have settings for all the possible trunks and channels.

In cases where the number of trunks or trunk channels in use is lower than the number

supported by the trunk card, the unused trunks and channel must be disabled.

Important:

Failure to do this will cause problems with outgoing calls.

Procedure

1. From the System Manager console, select the B5800 Branch Gateway device and

click Edit to edit the system configuration for the device. IP Office Manager will be

launched on your PC. For more information, see

Editing a B5800 Branch Gateway

system configuration from System Manager on page 159.

2. In the left navigation pane, click Line.

3. For each line, set those lines or channels that are not connected or not being used

as Out of Service.

The location of the relevant setting varies for each trunk type.

4. For Analog Trunks, set the Trunk Type to Out of Service.

5. For BRI, E1 PRI, S0 and QSIG Trunks, set the channels quantities to match the

actual subscribed channels.

6. For T1, T1 PRI and E1R2 Trunks, select the Channels tab. Then do the following:

Select those channels that are not used and click Edit.

• For T1 set the Type to Out of Service

• For T1 PRI set the Admin field to Out of Service.

• For E1R2 trunks set the Line Signalling Type to Out of Service.

7. Select File > Save Configuration.

Disabling unused trunks

Implementing B5800 Branch Gateway for a CS 1000 Configuration October 2012 135

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 323 324

Sem comentários

Avaya B5800 Manual do Utilizador Página 135