Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual do Utilizador descarregar pdf (Página 66)

Configuring SNMP, BootP, DHCP, and RARP Services

3-6

117362-C Rev 00

Specifying a Lock Address

The default lock address is 0.0.0.0. To specify a lock address, navigate to the

SNMP prompt and enter:

lock-address

address

is an IP address in dotted-decimal notation.

Specifying a Lock Timeout Value

If the SNMP locking mechanism is enabled, you can customize the lock timeout

period. The lock timeout period is the maximum number of minutes the SNMP

agent allows an idle network management station to hold a lock on it. During this

time, the SNMP agent locks out SNMP

set

commands from other network

management stations. The lock timer is reset each time the locking manager issues

an SNMP

set

command.

By default, the SNMP agent allows an idle network management station to hold a

lock on it for 2 minutes. To change the default lock timeout period, specify a value

from 1 to 60 minutes.

Using the BCC

To specify the number of seconds, navigate to the SNMP prompt and enter:

lock-timeout

integer>

integer

is the number of seconds.

Note:

There is no Site Manager command for specifying a lock address.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 175 176

Sem comentários

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual do Utilizador Página 66