Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual do Utilizador descarregar pdf (Página 63)

Customizing SNMP

117362-C Rev 00

3-3

Customizing SNMP Global Parameters

You can enable SNMP services most easily by accepting all the default parameter

values. However, you may want to change these values, depending on your

network requirements.

Disabling and Reenabling SNMP

When you enable IP on an interface, SNMP access is automatically enabled

through that interface, and default values are in effect for all SNMP parameters

(see Appendix B for parameter defaults).

Using the BCC

To disable SNMP, navigate to the SNMP prompt and enter:

disable

For example, the following command disables SNMP:

snmp# disable

To reenable SNMP, navigate to the SNMP prompt and enter:

enable

For example, the following commands reenable SNMP and display its default

values:

snmp# enable

snmp# info

on box

state enabled

lock enabled

lock-address 0.0.0.0lock-timeout 2

authentication-traps enabled

type-of-service reliability

scope-delimiter 0x40 (=> This function is not available)

snmp#

Specifying Maximum Successive Alarms

✓

Specifying Polling Intervals for Held Variables

✓

Specifying a Threshold Object Name

✓

Table 3-1. SNMP Configuration Tasks

(continued)

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 175 176

Sem comentários

Avaya Configuring SNMP, BOOTP, DHCP, and RARP Services Manual do Utilizador Página 63