Avaya Configuring Frame Relay Services Manual do Utilizador descarregar pdf (Página 39)

Frame Relay Overview

114058 Rev. A 2-15

Conﬁguring Synchronous Lines for Frame Relay

If you enable Frame Relay on a circuit, Site Manager automatically sets the

following synchronous line parameters

(Table 2-2):

For more information on these parameters, refer to Conﬁguring Line Services or

Conﬁguring Customer Access and Trunks (BNX Software), depending on the type

of installed software.

For More Information about Frame Relay

For more information about Frame Relay, consult the following documents:

American National Standards Institute, T1.617-1991. Integrated Services Digital

Network (ISDN) – Digital Subscriber Signalling System No. 1 (DSS1) - Signalling

Speciﬁcation for Frame Relay Bearer Service. Washington, D.C., June 1991.

-- T1.617 Annex D-1991. Additional Procedures for Permanent Virtual

Connections (PVCs) Using Unnumbered Information Frames. Washington, D.C.,

June 1991.

-- T1.618-1991. Integrated Services Digital Network (ISDN) - Core Aspects of

Frame Protocol with Frame Relay Bearer Service. Washington, D.C., June 1991.

Bradley, T.; Brown, C.; and Malis, A. RFC 1490, Multiprotocol Interconnect over

Frame Relay. Menlo Park, California: Network Information Center (NIC), SRI

International, January 1992.

Digital Equipment Corporation et al. T1S1 - Standards based Frame Relay

Speciﬁcation with Common Enhancements. Document Number 001-208966,

Revision 1.0, September 1990.

Table 2-2. Synchronous Line Parameters for Frame Relay

Parameter Value

BOFL Disable

Promiscuous Enable

Service Transparent

WAN Protocol Frame Relay

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 67 68

Sem comentários

Avaya Configuring Frame Relay Services Manual do Utilizador Página 39