Avaya Configuring PPP Services Manual do Utilizador descarregar pdf (Página 81)

Customizing PPP

117360-A Rev. A 3-27

Setting a Time Limit for Authentication

You can specify the maximum number of seconds the router waits for a response

to its authentication messages by setting the Authentication Timer parameter. If

the timer expires before the negotiation completes, the router drops the

connection. The default value is 10 seconds.

Using the BCC

The BCC does not allow you to conﬁgure this parameter.

Using Site Manager

To set a time limit for this interface, do the tasks in the following table.

Customizing PAP

When PAP is the authentication protocol, you must also specify a local PAP ID, a

local PAP password, and a remote PAP ID and remote PAP password for the peer.

During the authentication phase of link creation, PPP uses these parameters to

verify the peer’s right to communicate with the local router.

Site Manager Procedure

You do this System responds

1. From the Protocols menu, choose PPP. The Interfaces menu appears.

2. Choose Interfaces. The Interfaces window opens.

3. Choose Lines. The Lines window opens.

4. Set Authentication Timer.

(See page A-27.)

5. If you have no other PPP line parameters

to conﬁgure, click on OK. Otherwise,

continue with the Lines conﬁguration.

The Interfaces window opens.

Note: For dial services that use PAP, you must conﬁgure the local PAP ID, the

local PAP password, the remote PAP ID, and the remote PAP password

through the Dial menu. See Conﬁguring Dial Services for details.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 139 140

Sem comentários

Avaya Configuring PPP Services Manual do Utilizador Página 81