Avaya Configuring Ethernet, FDDI, and Token Ring Services Manual do Utilizador descarregar pdf (Página 34)

Configuring Ethernet, FDDI, and Token Ring Services

2-10 117020-A Rev. A

You can set the advertised line speed to

• 100Base-TX, half-duplex only

• 100Base-TX, full-duplex only

• 100Base-TX, both half- and full-duplex

• No advertising

To maximize throughput, operate at half-duplex (the default setting). Conﬁguring

one of the full-duplex settings will not increase throughput and may, in some

cases, decrease throughput. Use a full-duplex setting only to allow operation at

greater distances over ﬁber optic cable.

Viewing Line Negotiation Status

To view the current line negotiation status:

1. Start at the Auto Negotiation Conﬁguration prompt (refer to Figure 2-3).

2. Click on View Auto Negotiation Status.

The Auto Negotiation State Information window appears (F

igure 2-5). This

window provides details about the current line conﬁguration. T

able 2-2

provides information about the status display.

3. Proceed as follows, depending on the status of the transaction:

• If negotiation or data transmission is taking place, click on OK.

The Auto Negotiation State Information window closes, and negotiation

or data transmission continues.

• If there is a problem with the line, click on Restart.

This action resets all automatic line negotiation parameters and restarts

the line negotiation process.

Site Manager: Line Advertising Capabilities parameter: page A-5

Note: Site Manager can report line negotiation status only in dynamic mode.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 81 82

Sem comentários

Avaya Configuring Ethernet, FDDI, and Token Ring Services Manual do Utilizador Página 34