Avaya Configuring BFE Services Manual do Utilizador descarregar pdf (Página 58)

Configuring GRE, NAT, RIPSO, and BFE Services

3-14

305753-A Rev 00

Using Site Manager

Before you can start NAT on the router, you must configure a circuit that the

protocol can use as an interface to an attached network. For information and

instructions, see Configuring Ethernet, FDDI, and Token Ring Services or

Configuring WAN Line Services.

To start NAT on a router using Site Manager:

Configure NAT on the router and on the local IP interface.

Configure NAT on the global interface.

Configure a local address range and a global address range.

These steps are described in the following sections.

Starting NAT on the Router and Specifying the Local Interface

The local interface is connected to the internal network that includes the networks

within the local address range. The router performs address translation only on

packets from local hosts included in the local address range.

To start NAT on the router and on a local interface, complete the following tasks:

Site Manager Procedure

You do this System responds

1. In the Configuration Manager window,

click on the connector that you want to

configure as the NAT local interface.

The Edit Connector window opens.

2. Click on

Edit Circuit

. The Circuit Definition window opens.

3. Choose

Protocols

. The Protocols menu opens.

4. Choose

Add/Delete

. The Select Protocols window opens.

5. Click on

NAT

6. Click on

OK.

The NAT Global Configuration window

opens.

7. Click on

to accept the default values

for NAT global parameters.

The NAT Interface Configuration window

opens.

(continued)

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 179 180

Comentários a estes Manuais

Sem comentários

Avaya Configuring BFE Services Manual do Utilizador Página 58

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Avaya Configuring BFE Services