
Configuring APPN Services
2-2 114049 Rev. A
Enabling APPN over LLC2 Interfaces
When you configure APPN on LLC2 interfaces, such as Ethernet and Token Ring,
the Configuration Manager requests media access control (MAC) and service
access point (SAP) addresses. On synchronous interfaces where you are
configuring APPN over Frame Relay, the Configuration Manager requests a data
link connection identifier (DLCI) address and a SAP address.
To enable APPN on Ethernet, Token Ring, or Bay Networks synchronous
interfaces using Frame Relay:
1. Select APPN from the Select Protocols window.
This menu appears after you select either a link or net module connector that
requires a WAN circuit. The Configuration Manager automatically selects the
LLC2 option.
2. Click on OK.
For Frame Relay and Ethernet networks, the “Use Source Route
Encapsulation?” dialog box appears (Figure
2-1).
3. Click on Cancel if you are configuring standard LLC over Ethernet, or if
you are configuring Frame Relay using the RFC 1490 routing standard.
Caution: The Technician Interface does not verify that the value you enter for
a parameter is valid. Entering an invalid value can corrupt your configuration.
Comentários a estes Manuais