Avaya BCM50 Guia de Configuração descarregar pdf (Página 37)

AT&T IP Flexible Reach and AT&T IP Flexible Reach with AT&T Business in a Box

Nortel BCM50 Release 3.0 SIP Configuration Guide

*Nortel, Nortel Networks, Nortel (Logo), the Globemark, CS1000 are trademarks of Nortel Networks.

Issue 1.5 Page 37 of 38

6 APPENDIX A: Configuring Destination Code with

Wildcard

In an inbound call scenario, the leading digit sent to the BCM50 may be the

same as the digit used in the destination code. Without configuring for a

wildcard; the BCM50 will interpret the call as a tandem call, and will fail to

terminate the call on the BCM50. To remedy this, it is recommended to

configure destination code with wildcard.

If the IP Flexible Reach sends a site prefix that is the same as the digit being

used for the destination code; please use the following configuration example.

In this example, the number sent to the BCM50 is the following: “961170”. To

configure the BCM50 for this call, use the following wildcard configuration.

Under

Configuration 



 Telephony 



 Dialing Plan 



 Routing

, under the

Destination Codes

tab, add the destination code “9A” to use Normal Route

“001.” Configure the absorbed length to 1 so that the BCM50 will absorb the ‘9’

only in an outbound call scenario. Uncheck the digit following the ‘9’ in the

incoming digits to the BCM50 (in this example, the ‘6’ in “961170”).

Figure 30: Configuring Destination Code with Wildcard

1 2 ... 32 33 34 35 36 37 38

Sem comentários

Avaya BCM50 Guia de Configuração Página 37