Avaya R2MFC Guia de Configuração descarregar pdf (Página 39)

Chapter 3 Installing the R2MFC MBM 39

R2MFC Media Bay Module Installation and Configuration Guide

Figure 13 Trunk wiring overview

Connecting an R2MFC MBM to a service provider

Perform the following steps to connect an R2MFC MBM to the network:

1 Determine the connector type to be used, either RJ48C or BNC connectors.

2 Locate the appropriate connector on the front of the module.

3 Attach the transmit BNC cable to the connector labeled Tx and the receive BNC cable to the

connector labeled Rx, for countries using BNC connections. Insert the connector into the RJ48

Warning: Electrical shock warning.

The Business Communications Manager R2MFC MBMs have been safety-approved for

installation into BCM base units and expansion units. Both the installer and user are

responsible to ensure that installation of the Business Communications Manager hardware

does not compromise existing Safety approvals.

BEFORE YOU OPEN the Business Communications Manager base unit or Business

Communications Manager expansion unit, ensure that the network telecom cables are

unplugged, and that the unit is then disconnected from the ac power source.

Station modules: The ports on these modules are meant to be connected only to approved

digital telephones and peripherals, with the proper cables, on a protected internal wiring

system.

Do not connect any telephones to wiring that runs outside the building.

Read and follow the installation instructions carefully.

Install R2MCF MBM

Read warnings

Determine the correct

connector to use

Connect cables to

appropriate trunk

modules

Continue with setup

procedures

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 105 106

Sem comentários

Avaya R2MFC Guia de Configuração Página 39