Avaya R2MFC Guia de Configuração descarregar pdf (Página 35)

Chapter 3 Installing the R2MFC MBM 35

R2MFC Media Bay Module Installation and Configuration Guide

Removing an R2MFC MBM

Follow the procedures in this section to remove an R2MFC MBM from a BCM platform base

chassis or expansion unit.

Figure 8 provides an overview of the process for removing an R2MFC MBM.

Figure 8 Overview of removing an R2MFC MBM

Removing an R2MFC MBM from the BCM platform base chassis

Perform the following steps to remove an R2MFC MBM from the BCM platform base chassis.

Remove the R2MFC MBMs after the system is powered down.

1 Power-down the BCM system (see “Shutting down the system” on page 31).

2 Remove any cabling from the R2MFC MBM faceplate.

3 Grasp the right edge of the MBM ejector lever with your thumb, index, and middle fingers.

Pull outward to partially eject the R2MFC MBM. Pull further on the lever to eject the R2MFC

MBM from the bay. Figure 9 on page 36 shows how to remove a BCM 200 R2MFC MBM.

Figure 10 on page 36 shows how to remove a BCM 400 R2MFC MBM.

4 Grasp the top and bottom edges of the R2MFC MBM. Remove the R2MFC MBM from the

BCM platform base chassis MBM bay (see Figure 9 on page 36 and Figure 10 on page 36).

Place the R2MFC MBM in a clean, safe, and static-free area.

Shut down BCM and

expansion unit

Disconnect power from

both units

Remove module cables

Remo ve mo d ule

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 105 106

Sem comentários

Avaya R2MFC Guia de Configuração Página 35