Avaya R2MFC Guia de Configuração descarregar pdf (Página 24)

24 Chapter 1 Overview

N0027684 01

RS232 port

There is an RJ-45 serial port connector named RS232 on the faceplate of the R2MFC MBM. The

N0026100 cable, shipped with the R2MFC MBM, is used to connect a computer to the RS232 port

for advanced configuration or for CLI-based diagnostics of the R2MFC MBM. Appendix D, “CLI

Cable Pinout,” on page 105 shows the pinout information to make a new N0026100 cable.

E1 Status LEDs

The R2MFC MBM has four visual status monitor indicators in the middle section of the faceplate.

They are:

• ERR Tx — indicates a Transmit error on the E1

• ERR Rx — indicates a Receive error on the E1

• ALM Tx — indicates a Transmit alarm on the E1

• ALM Rx — indicates a Receive alarm on the E1

Bantam jacks

The R2MFC MBM contains Bantam Jacks in the middle of the faceplate, to be used for connecting

diagnostic equipment. The jacks are labeled DIAG.

BNC and RJ-48 connectors

The R2MFC MBM has both BNC and RJ-48 external E1 connectors located on the far right of the

faceplate. These connectors are used to connect the R2MFC MBM to the Central Office (CO).

The default interface will be based on the country code selected. Mexico is the factory default. See

Appendix A, “Config DIP switch settings and definitions,” on page 85 for the country code default

settings.

R2MFC MBM back and underside elements

The back and underside of the R2MFC MBM contain the following elements:

• “Power connectors” on page 24

• “MBM DIP switches” on page 25

Power connectors

The R2MFC MBM receives its power from the BCM chassis through a power connector on the

back of the module.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 105 106

Sem comentários

Avaya R2MFC Guia de Configuração Página 24